Deleted Agent Not seen in List of Inactive Agents from AppAdmin Page

Available Languages

Download Options

PDF (66.3 KB)
View with Adobe Reader on a variety of devices

Updated:January 26, 2009

Document ID:108557

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

Before You Begin

Requirements

Components Used

Conventions

Problem

Solution

Manual Steps to Bring the Agent to the List of Inactive Agents

Related Information

Introduction

This document explains how to troubleshoot when a deleted agent does not appear in the AppAdmin Inactive Agents List.

Before You Begin

Requirements

Cisco recommends that you have knowledge of these topics:

Cisco Unified Contact Center Express
Microsoft Active Directory Administration

Components Used

The information in this document is based on these hardware and software versions.

Cisco Unified Contact Center Express 4.0(x) with Active Directory (AD) integration
Microsoft Windows Server
Microsoft Active Directory Administration (ADSI edit)

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Problem

The deleted agent resources must appear in the List of Inactive Agents on the CRS AppAdmin page before they are deleted. In the CRS AppAdmin Page, choose Subsystems > RmCm and click Resources.

You can see a link to the Inactive Agents on this page. Click the link to view the List of Inactive Agents, as shown.

In some cases, when an agent is removed from your IPCC Express server, an agent resources does not go to the inactive state. You are not able to fully delete an agent in this situation. The next section describes how to troubleshoot this issue.

Solution

Manual Steps to Bring the Agent to the List of Inactive Agents

Complete these steps:

Choose CRS AppAdmin > System > LDAP Information, and make a note of these specified values:
- LDAP Administrator Username
- Apps Base location
You need to use the Active Directory Services Interface (ADSI) edit utility in order to manually delete the agent. On the AD Server, launch the ADSI edit utility and enter the Microsoft Management Console (MMC) with the username credentials from step 1.
In ADSI, navigate to the Apps Base location from step 1.
Drill down to OU=profiles and select it. In the right pane of the window, locate the ciscoCCNocAppProfile for the IPCC express user agent to be removed.
Right click the ciscoCCNocAppProfile for the IPCC express user agent and choose delete.
If the delete fails, you need to apply the correct permissions for the LDAP administrator username within active directory and try again.
If the delete is successful, choose AppAdmin > Subsystems > RmCm > Resources > Inactive Agents and the IPCC express user agent appears in the list.