Guest

Cisco Unified Communications Manager (CallManager)

Troubleshoot RTMT Partition Space Availability Alert

Document ID: 107494

Updated: Jun 27, 2008

   Print

Introduction

This document describes the alert that appears within the Real-Time Monitoring Tool (RTMT) and the necessary steps in order to troubleshoot it.

Prerequisites

Requirements

Cisco recommends that you have knowledge of Cisco Unified Communications Manager 5.x and RTMT.

Components Used

The information in this document is based on Cisco Unified Communications Manager 5.x.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Problem

In the Cisco CallManager server, a Swap Partition available disk space below 10 Percent. LowSwapPartitionAvailableDiskSpace partition has 7 percent of available disk space alert appears from the RTMT.

rtmt-alert1.gif

Solution

This alert indicates that the swap partition is left with very less available space, and is heavily used by the system. The swap partition is normally used to extend the physical RAM capacity when needed. In normal conditions, if RAM is enough, swap should not be used too much.

This alert appears when the default threshold for available disk space is set to a high value. In order to stop the RTMT alert, Cisco recommends to set the default threshold for available disk space to a lower number, for example, less than two percent.

Complete these steps in order to stop this alert in the RTMT:

  1. Log into RTMT.

  2. Choose Tools > Alert > Alert Central.

  3. Right-click LowActivePartitionAvailableDiscSpace.

  4. Choose Set Alert Properties.

  5. Click Next.

  6. Change the value to 1 or 2%.

  7. Click Next/Next.

  8. Click Activate.

    Note: As this alert can be caused by a build up of temp files, a reboot of the server is recommanded to clear out any unnecessary temp files.

    Note: Turn off any unnecessary traces configuration. Traces should only be turned on during troubleshooting.

Related Information

Updated: Jun 27, 2008
Document ID: 107494