This document discusses how to resolve the login problem with the Cisco CallManager Operating System Administration web page.
Cisco recommends that you have knowledge of these topics:
The information in this document is based on these software and hardware versions:
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
In Cisco Unified CallManager 5.x, you need to login into the Cisco Unified Communications Operating System Administration web page in order to perform many common system administration functions. You can perform these system functions through OS Admin page.
Check software and hardware status.
Check and update IP addresses.
Ping other network devices.
Manage NTP servers.
Upgrade system software and options.
Restart the system.
You can access Cisco Unified CallManager Administration, Cisco Unified CallManager Serviceability, and Cisco Unified Communications Administration if you use these browsers:
Note: Cisco does not support or test other browsers.
Complete these steps in order to access Cisco Unified Communications Operating System Administration and login:
Login into Cisco Unified CallManager Administration with the CCMAdministrator username and password. Both username and password are case-sensitive.
From the Navigation menu in the upper right corner of the Cisco Unified CallManager Administration window, choose Cisco Unified OS Administration and click Go.
Note: You can also access Cisco Unified Communications Operating System Administration directly if you enter this URL: http://<ip address>/iptplatform.
The Administrator username and password gets established during installation or created with the command line interface. This is different from the Cisco Unified CallManager Administration username and password.
Note: Only one account can be used for Cisco Unified Communications Operating System Administration. MLA cannot be enabled for the Operating System administration account.
If you do not remember the Administrator password and cannot access the system, complete these steps in order to reset the OS Administrator password.
Note: During this procedure, you are required to remove and then insert any valid CD or DVD in the disk drive to prove that you have physical access to the system.
Complete the steps in the given procedure in order to recover the password after inserting any valid CD or DVD into the disk drive:
Log in to the system with this username and password:
If you have a CD or DVD in the disk drive, remove it now and press any key in order to continue.
The system tests to ensure that you have removed the CD or DVD from the disk drive.
After the system verifies that you have inserted the disk, you get prompted to enter a new Administrator password.
The system resets the Administrator username to admin. If you want to set up a different Administrator username and password, use the CLI command set password
Reenter the new password. The password must be at least six characters long and should not be a common name.
After the system verifies the strength of the new password, the password gets reset, and you are prompted to press any key in order to exit the password reset utility.