Guest

Cisco Small Business IP Phones

Upgrading the Firmware of SPA962 Phone

Cisco - Upgrading the Firmware of SPA962 Phone

Document ID: 109139

Updated: Dec 12, 2008

   Print

Introduction

This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Q. How do I upgrade my SPA962 Phone firmware?

A. The latest firmware file(s) for the SPA9xx Series Phone can be downloaded from http://www.cisco.com/support. Firmware files are packaged in zip compressed format. Each file contains a windows binary ".exe", a raw firmware ".bin" file, a recovery tool ".exe" and the release notes ".txt".

There are two ways to upgrade the firmware:

  1. Run the windows executable from a windows PC.

  2. Load the firmware on the TFTP server.

Note: Before you complete this procedure, make sure that the upgrade enable is set to YES in the provisioning tab of SPA-962.

Complete these steps:

  1. Access the web based setup page of the SPA-962. Verify the IP address through the LCD. Click on the Menu button then press 9. It should show you the DHCP IP address. Open a browser and type that in the Address bar.

    KB16848-001_EN.png

  2. Click on Admin Login and then advanced.

    KB16848-002_EN.png

    Note: The SPA962 does not have a username and password by default. If you are asked for a username and password, it means that the SPA962 is locked. You need to verify this with your VoIP provider.

  3. Go to the provisioning tab and under Firmware Upgrade section, set upgrade enable to YES and click submit all changes.

    KB16848-003_EN.png

Runthe windows executable from a windows PC

Complete these steps:

  1. Double-click the .exe file in order to run the windows executable file on your PC. Read the warning instruction first, then click on Continue if you want to continue the firmware upgrade.

    KB16848-004_EN.png

  2. Provide the IP address of your SPA962 phone then choose OK. Do not power off the SPA962 during this process.

    KB16848-005_EN.png

  3. A progress bar should appear that indicates the upgrade process. Click OK after it confirms that it loaded the firmware successfully.

    KB16848-006_EN.png

Loading the firmware via TFTP server

You can also place the raw firmware image spa.bin on a reachable TFTP server. Go to your web browser, and type in: http://spa-ip-address/upgrade?tftp://tftp-server-ip/spa.bin

The SPA device can use http in place of the tftp method. Do not power off the SPA device during this procedure.

KB16848-007_EN.png

Related Information

Updated: Dec 12, 2008
Document ID: 109139