Set up a PlayStation 2 with a Cisco Small Business VoIP Router

Introduction

This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.

Note: Before you proceed, note that Cisco Small Business does NOT support the configuration of PlayStationregTag;2. These instructions simply tell you how to configure the router for the PlayStationregTag;2, not the game console itself. For technical support on the PS2regTag;, contact Sony.

In order to set up a PlaystationregTag;2 on the Cisco Small Business router, complete these steps:

1. Set up the PlaystationregTag; 2
2. Configure the Router

Set up the PlayStationregTag;2

Step 1:
After you install your PlayStationregTag;2 Network Adapter, connect a regular straight thru cable from one of the numbered ports on the router. Plug the other end of the cable into the PlayStationregTag;2's Network Adapters Ethernet port.

Step 2:
You must assign a static IP address on PlayStationregTag;2. To do that, please consult your PlayStationregTag;2 documentation, or click here. In this example "192.168.15.20" was used for the IP Address, "255.255.255.0" for the Subnet mask, "192.168.15.1" for the Default Gateway, and your DNS information.

Once the PlayStationregTag;2 is set-up, complete the steps in the next section in order to configure the Cisco Small Business router.

Configure the Router

Step 1:
Access the router's web-based setup page. For instructions, click here.

Step 2:
When the router's web-based setup page appears, click Applications and Gaming > DMZ.

Step 3:
Select Enabled, and enter the PlayStationregTag;2's IP address in the DMZ Host IP Address field.

Step 4:

Click .

Related Information

• Technical Support & Documentation - Cisco Systems