Guest

Cisco Unified Intelligent Contact Management Enterprise

How to Use the vrutrace Utility

Cisco - How to Use the vrutrace Utility

Document ID: 20553

Updated: Apr 03, 2005

   Print

Introduction

This document discusses how to use the vrutrace utility. The vrutrace utility allows the retrieval of specified log files related to the Peripheral Interface Manager (PIM) process of a Peripheral Gateway (PG) when it is connected to a Voice Response Unit (VRU) in a Cisco Intelligent Contact Management (ICM) Enterprise Edition environment.

Prerequisites

Requirements

Readers of this document should have knowledge of these topics:

  • Cisco ICM PG configuration

  • Knowledge of VRU

Components Used

The information in this document is based on these software and hardware versions:

  • Cisco ICM versions 4.5.x and later

  • Microsoft Windows NT version 4.0 or Microsoft Windows 2000

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

About the vrutrace Utility

The vrutrace utility enables you to retrieve specified log files related to the PIM process of a PG when it is connected to a VRU.

How to Use the vrutrace Utility

This section explains how to use the vrutrace utility.

Start the vrutrace Utility

To execute the vrutrace utility, ensure that your computer is:

  • Connected through a DOS prompt or a telnet session to the PG that contains the log you need.

  • At the c:\icr\custname\pgxx\vrucap subdirectory for versions earlier than 5.0, or at the c:\icm\custname\pgxx\vrucap subdirectory for versions 5.0 and later.

    Note: Here, custname and pgxx are customer specific. For example, if the customer is XYZ and the PG is PG1A, the subdirectory is c:\icr\xyz\pg1a\vrucap.

Here are the options for the vrutrace utility:

vrutrace [ProcessName] [/if InputFile] [/o] [/of OutputFile] 
        [/bd BeginDate(mm/dd/yy)] [/bt BeginTime(hh:mm:ss)] 
        [/ed EndDate(mm/dd/yy)] [/et EndTime(hh:mm:ss)] [/all] [/prev] 
        [/last] [/binary] [/debug] [/sleep] [/htbt] [/vrustat] [/help] 
        [/?]

Examples for How to Use the vrutrace Utility

Example 1

This example shows how you can obtain the output from a log file with information from April 29, 2000 until April 30, 2000 with binary data.

c:\icr\xyz\pg1a\vrucap\vrutrace pim1 /bd 04/29/2000 /ed 04/30/2000 /binary

Example 2

This example shows how you can obtain output from a log file with information from the last time the process ran to the current date and time.

c:\icr\xyz\pg1a\vrucap\vrutrace pim1 /last

Related Information

Updated: Apr 03, 2005
Document ID: 20553