Guest

Cisco Small Business Voice Systems

Accessing the Web-Based Setup Page of the SPA9000

Document ID: 108812

Updated: Dec 12, 2008

   Print

Contents

Introduction
How do I access the setup page of SPA9000?
Related Information

Introduction


This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.

Q. How do I access the setup page of SPA9000?

A.

When accessing the web-base setup page, complete these instructions:

Accessing the Web-Based Setup Page

Step 1:
Plug an analog telephone into the Phone 1 port of the System (optional).

Note: If you have a second analog telephone or fax machine, plug it into the Phone 2 port of the System.

Step 2:
Connect the Ethernet cable to the Internet port of the System. Then connect the other end of the cable to one of the Ethernet ports on your router.

Step 3:
Connect a different Ethernet network cable to the Ethernet port of the System. Then connect the other end to the computer you will use to manage the System, this will become the administration computer.

Step 4:
Connect the included power adapter to the Power port of the System, and then plug the power adapter into an electrical outlet. The Status LED will start flashing as the System boots up.

Step 5:
Launch the web browser on the administration computer. Enter "http://192.168.0.1/admin/voice/advanced" in the Address field then press [Enter].

Note: 192.168.0.1 is the default local IP address of the System.

Do not connect the Phone port to a telephone wall jack. Make sure you only connect a telephone or fax machine to the Phone port. Otherwise, the System or the telephone wiring in your home or office may be damaged.

Related Information

Updated: Dec 12, 2008
Document ID: 108812