Guest

Cisco Small Business Voice Gateways and ATAs

Making NodePhone Changes on the SPA3000

Document ID: 108739

Updated: Dec 12, 2008

   Print

Contents

Introduction
How can I make NodePhone changes on the SPA3000?
Related Information

Introduction


This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.

Q. How can I make NodePhone changes on the SPA3000?

A.

You have the option to make NodePhone changes to make your SPA3000 sound more Australian. For instructions, complete these steps:

Step 1:
Access the SPA3000's web-based setup page. For instructions, click here.

Step 2:
Click Admin Login, then advanced.

Step 3:
Click Regional, and go to the Call Progress Tones section.

Step 4:
Look for Dial tone, and enter "400@-16,425@-16,450@-16;10(*/0/1+2+3)" in the field provided.

Step 5:
Look for Second Dial Tone, and enter "420@-19,520@-19;10(*/0/1+2)" in the field provided.

Step 6:
Look for Outside Dial Tone, and enter "420@-16;10(*/0/1">"420@-16;10(*/0/1)" in the field provided.

Step 7:
Look for Prompt Tone, and enter "520@-19,620@-19;10(*/0/1+2)" in the field provided.

Step 8:
Look for Busy Tone, and enter "425@-16;10(.375/.375/1)" in the field provided.

Step 9:
Look for Ring Back Tone, and enter "440@-19,480@-19;*(2/4/1+2)" in the field provided.

Step 10:
Go to the Distinctive Ring Patterns section. Look for Ring1 Cadence, and enter "60(.4/.2,.4/2)" in the field provided.

Step 11:
Look for Ring2 Cadence, and enter "60(.3/.2,1/.2,.3/4)" in the field provided.

Note: After making all the changes outlined above, your SPA3000 device should successfully connect to NodePhone and sound like an Australian phone service.

Related Information

Updated: Dec 12, 2008
Document ID: 108739