Resetting SPA2100

Available Languages

Updated:December 12, 2008
Document ID:108805

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Contents

Introduction
How do I reset SPA2100?
Related Information

Introduction


This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).

Q. How do I reset SPA2100?

 A.

Step 1:
Pick up the phone handset attached to the SPA2100 and dial ****73738#

Step 2:
Press 1# to confirm then hang up.

Note: The device will reboot with factory-default configuration. All previously entered settings will be erased. It is possible for service providers to restrict access to the reset function. If you are using an SPA2100 that has been provisioned by an ITSP, you may need their assistance to perform this action.

Related Information

Revision History

Revision Publish Date Comments
1.0
12-Dec-2008
Initial Release

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products