Guest

Cisco Small Business Voice Gateways and ATAs

Accessing the SPA2100's Web-Based Setup Page

Document ID: 108786

Updated: Dec 12, 2008

   Print

Contents

Introduction
How do I access the SPA2100's web-based setup page?
Related Information

Introduction


This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.

Q. How do I access the SPA2100's web-based setup page?

A.

All SPA devices have a built-in web-based setup page that allows the user to customize settings and set up advanced properties. For instructions on how to access the SPA2100's web-based setup page, complete the steps in this document.

Note: Before accessing the SPA2100's web-based setup page, make sure the router is powered on and the computer is wired to the LAN port of the SPA unit.

Accessing the SPA2100's Web-Based Setup Page

Step 1:
Open a web browser such as Internet Explorer.

Step 2:
Go to the Address bar and enter the SPA2100's IP Address (by default the IP address of the SPA2100 is 192.168.0.1) then press [Enter].

The SPA2100's web-based setup page should open.

Note: Access to the SPA2100's Admin Login-Advanced page does not require a password by default. SPA2100 units acquired though ITSPs, however, are generally password-protected for security reasons, denying access to the Admin Login and rejecting changes applied to existing configuration. If the unit is purchased from a reseller, it can be restored to default settings through factory reset using the IVR. For IVR instructions, click here.

Related Information

Updated: Dec 12, 2008
Document ID: 108786