Guest

Cisco Small Business Voice Gateways and ATAs

Accessing the SPA2100's Interactive Voice Response (IVR) Menu

Document ID: 108781

Updated: Dec 12, 2008

   Print

Contents

Introduction
Accessing the SPA2100 Interactive Voice Response (IVR) Menu
Related Information

Introduction


This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.

Q. Accessing the SPA2100 Interactive Voice Response (IVR) Menu

A.

In order to access the Interactive Voice Response (IVR) menu, complete these steps:

Step 1:
Dial **** on the analog phone attached to the SPA2100.

Step 2:
When you hear the voice prompt, dial the corresponding IVR menu code/number followed by the pound (#) key.

Step 3:
In order to check the SPA2100's current WAN IP address, pick up the phone attached to the SPA unit and dial ****110#.

Note: Here is the list of IVR menu codes:



Note: If the Administrator password is not set or the user is allowed to change it, the items marked with Requires Password will not require a password.

 

Related Information

Updated: Dec 12, 2008
Document ID: 108781