Configure Idle User Logout Timer in EPNM GUI

Available Languages

Download Options

  • PDF     (174.9 KB)
    View with Adobe Reader on a variety of devices
  • ePub     (263.7 KB)
    View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
  • Mobi (Kindle)     (212.2 KB)
    View on Kindle device or Kindle app on multiple devices
Updated:August 19, 2022
Document ID:218061

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

    Introduction

    This document describes the steps to change the idle user logout timer in Evolved Programmable Network Manager (EPNM).

    Prerequisites

    Requirements

    Cisco recommends that you have knowledge of EPN Manager.

    Note: Need to have access to EPNM GUI.

    Components Used

    The information in this document is based on EPNM.

    The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, ensure that you understand the potential impact of any command.

    Configure

    You must make this change at two levels (System Level and User Level).

    System Level

    Navigate toAdministration > Setting > System Settings.UnderGeneral,select Serverand change the timeout value as shown in this image:

    configuration GUI

    User Level

    Click the Settings icon on the top right and selectMy Preferences.

    configuration GUI

    Change the timeout value as desired and clickSave.

    configuration GUI

    Log out and log back in for the changes to take effect.

    Revision History

    Revision Publish Date Comments
    1.0
    23-Aug-2022
    Initial Release
    TAC Authored

    Contributed by Cisco Engineers

    • Sancho Felix

    Was this Document Helpful?

    FeedbackFeedback

    Contact Cisco

    This Document Applies to These Products