Get to Know the SG350-28P 28-Port Gigabit PoE Managed Switch

Objective

The Cisco SG350-28P 28-Port Gigabit Power over Ethernet (PoE)Managed Switch is a standalone switch that provides 24/28 ports of Gigabit Ethernet and 4/28 (2 SFP + 2 Combo) Gigabit Ethernet ports. It comes with a new generation, highly-integrated packet processor for Carrier Ethernet and Small-Medium Enterprise (SME) applications with full wire-speed performance.

This article aims to show the features of the SG350-28P 28-Port Gigabit PoE Managed Switch.

Applicable Devices

• SG350-28P

Software Version

• 2.1.0.63

SG350-28P Features

Product Features

• Link Flap Prevention
• Support auto detect 100M or 1000M Small Form-Factor Pluggable (SFP) modules and auto configure the correct speed.
  • The speed of the SFP ports can be manually configured
• USB port that allows the following:
  • Backing up of configuration files
  • Loading of new image or configuration files
• Quality of Service (QoS)

Egress policy

• • Egress ACL
  • 2 Rate 3 Colors (2R3C)
• Port Monitor/ Switched Port Analyzer (SPAN)
  • 7-session SPAN
  • Policy-based Flow Mirroring
• Switch Management
• Command Line Interface (CLI) Output modifier
• Bonjour IPv6 Support
• Web-based utility
  • Search
  • Wizards: Access Control List (ACL)
  • Save icon
  • Syslog Popup
  • Show tech-support
• Traffic Monitoring

- Counters History/Counters Graph

- SFLOW v5

• Packet Processor -€“ AlleyCat3: 98DX3235 (GE), 98DX1235 (FE)
• Embedded CPU - Marvell MSIS /400Mhz
• PHY-
  • 88E1680 -€“ Integrated Octal 10/100/1000 Mbps Energy Efficient Ethernet Transceiver
  • 88E3680 -€“ Integrated Octal 10/100 Mbps Energy Efficient Ethernet Transceiver
  • 88E1543 -€“ Combo port support
• DRAM - 512 MB (DDR3)
• Flash - 256 MB NAND Flash
• Protocol Based Virtual Local Area Network (VLAN)
• IP Subnet Based VLAN
• Logging aggregation disabled by default

Ports

• Power over Ethernet (PoE) Support
• 60W PoE
• PoE Link Layer Discovery Protocol (LLDP), Cisco Discovery Protocol (CDP) support (power negotiation)
• PD port support (PD70224 + PD70211)
• New PoE chipset allows devices to function as power client and request specific power consumption
• PoE controller embedded in Network ASIC (AC3) allows faster communication speed between the Network-ASIC and the PoE-chip
• 4-port AF/AT (Ports 1-2, 13-14)
• two Combo ports that consist of one RJ45 interface and one Mini-GBIC (SFP) interface
• Rest of the ports is Power Sourcing Equipment (PSE): AF/AT.
• PSE Port support: 24 ports
• Up to 12 simultaneous ports with full 15.4 support
• Console/Terminal Port (RJ45) for device management and debug
• asynchronous data of eight data bits
• one-stop bit
• no parity
• Default Baud rate of 115200 bps51H4FP1E51H4FP1E
• USB 2.0 port support
• FAT32 for Read/Write
• NTFS for Read-only

Buttons

• Reset button

LED Indication