View the Routing Table on an RV340 or RV345 Router

Available Languages

Download Options

  • PDF     (75.9 KB)
    View with Adobe Reader on a variety of devices
  • ePub     (145.8 KB)
    View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
  • Mobi (Kindle)     (254.3 KB)
    View on Kindle device or Kindle app on multiple devices
Updated:January 24, 2019
Document ID:1548365519050448

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

View the Routing Status on an RV340 or RV345 Router

Objective

Routing is the process of moving packets across a network from one host to another. The status of this process is displayed on a routing table. The routing table contains information about the topology of the network immediately around it. The routing table is typically used in order to determine the status of the delivery of the packets across the network for troubleshooting and monitoring purposes.

This article aims to show you how to view the routing table on an RV340 or RV345 router.

Applicable Devices

  • RV34x Series

Software Version

  • 1.0.02.16

View the Routing Table

Step 1. Log in to the web-based utility of the router.

Step 2. Choose Status and Statistics > Routing Table.

Note: If you are using an older version of firmware, you would navigate to Status and Statistics > Routing Status.

On the Routing Table page, the following information about IPv4 and IPv6 are displayed.

  • Destination — This is the Internet Protocol (IP) address and subnet mask of the connection.
  • Next Hop — This is the IP address taken by the packet immediately after leaving the source. The maximum number of hops that a packet can take is 15.
  • Metric — This is the number of routing algorithms when determining the optimal route for sending network traffic.
  • Interface — This is the name of the interface to which the route is attached to.
  • Source — This is the origin of the route.

You should now have successfully viewed the routing table page of your RV34x series router.

Was this Document Helpful?

FeedbackFeedback

Contact Cisco