UCS LSI Adapter Beeps Continuously

Available Languages

Download Options

PDF (20.8 KB)
View with Adobe Reader on a variety of devices

Updated:June 6, 2013

Document ID:116106

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document describes an issue that causes a Cisco Unified Computing System (UCS) server to beep continuously.

Problem

A Cisco UCS server beeps continuously; this beep originates from the LSI RAID adapter.

You can view the LSI MegaRAID Card Beep Codes in order to identify the specific alarm. Refer to LSI MegaRAID Card Beep Codes in the Cisco UCS Servers RAID Guide in order to view the beep codes.

If there are no failed drives reported by the Cisco Integrated Management Controller (CIMC), this problem might occur due to an issue described in this LSI MegaRaid firmware bug: LSIP200139764. Refer to the LSI Corp. MegaRAID Firmware Release notes for more information on this bug.

Note: TheLSI defect is reported as fixed in MegaRaid firmware 21.0.1-0111 and 21.0.1-0110. This issue affects any server vendor that uses these adapters (for example, Cisco, HP, and Dell).

Solution

If you want to avoid an LSI firmware upgrade, you can complete these steps in order to resolve this issue:

Install MegaCLI. Refer to the LSI Documents & Downloadspage in order to locate documentation on this procedure.
Run this command in MegaCLI in order to silence the alarm:
```
# MegaCli -AdpSetProp -AlarmSilence -aALL
```

You can also silence the alarm in the LSI MegaRAID BIOS Config Utility. However, be aware that this process requires a server reboot in order to access the WebBIOS. The alarm control is located in Controller Properties.