How do you create an LDAP group query on the ESA?

Available Languages

Download Options

  • PDF     (5.8 KB)
    View with Adobe Reader on a variety of devices
Updated:October 14, 2014
Document ID:118504

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document describes how to create an LDAP group query on the Email Security Appliance (ESA).

How do you create an LDAP group query on the ESA?

  1. Create an LDAP group query under System Administration > LDAP.
  2. Enable the group query for the listener under Network > Listener > {select the listener} > select the LDAP group query.
  3. Go to Incoming Mail Policies.
  4. Create a new policy for the group.
  5. Add in the recipient matching the group.
  6. Choose LDAP group query instead of email.
  7. Select group query and put in the matching group name.
  8. Configure new incoming mail policies: Anti-Spam, Anti-Virus, Content Filters, and Virus Outbreak Filters.

Further instructions on how to create an LDAP group query are available in the Online Help (GUI: Help and Support->Online Help)

Revision History

Revision Publish Date Comments
1.0
14-Oct-2014
Initial Release
TAC Authored

Contributed by Cisco Engineers

  • Khoa Nguyen and Enrico Werner
    Cisco TAC Engineers.

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products