What causes "collision error" alerts?

Available Languages

Download Options

  • PDF     (5.9 KB)
    View with Adobe Reader on a variety of devices
Updated:August 5, 2014
Document ID:118162

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document describes the causes of collision error alerts.

Collision error alerts are generated when the Ethernet settings on your Cisco Email Security Appliance (ESA) are incorrectly configured. Typically these errors occur when the media settings of the ESA and the switch port to which it is attached do not match.

Verify your network settings and make sure that both your network switch and your ESA are set to the same speed and duplex setting.

How do I configure the duplex settings of the network interfaces on the ESA?

The etherconfig CLI command can be used to configure various ethernet settings such as the duplex settings (full/half) and the throughput of the interface (10/100/1000 Mbps).

By default, interfaces automatically select the media settings; however, if the system is generating collision errors it might be necessary to override this setting.

For information about media settings on ethernet interfaces, see the AsyncOS Advanced Configuration Guide.

Revision History

Revision Publish Date Comments
1.0
05-Aug-2014
Initial Release
TAC Authored

Contributed by Cisco Engineers

  • Stephan Bayer
    Cisco TAC Engineer.

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products