This document explains the recovery/repair procedure for the Converged Infrastructure Video Security Device.
There are no specific requirements for this document.
This document is not restricted to specific software and hardware versions.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
This is the step-by-step recovery procedure:
Connect an external USB drive, and boot the box with the Gold CD.
Log on as root with the password cledne.
At the prompt, run these commands:
umount -f /dev/sda1
umount -f /dev/sda2
fsck.ext3 -f -yC 0 /dev/sda1 ==> It should take a few minutes.
fsck.ext3 -f -yC 0 /dev/sda2 ==> Will take some time (an hour or two)
When it is finished, run this command:
The box starts to reboot. Remove the USB CD cable from the box, and let the box boot from itself.