Cisco DSL Router Configuration and Troubleshooting Guide - PPPoE Implementation Options

Available Languages

Download Options

PDF (5.9 KB)
View with Adobe Reader on a variety of devices

Updated:September 25, 2006

Document ID:71120

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

Prerequisites

Requirements

Components Used

Conventions

Implementation Options

Related Information

PPPoE Option 1 The Cisco DSL Router is the PPPoE client. (Recommended) A PPPoE client feature was introduced into Cisco IOS® Software Release 12.1(3)XG. This feature allows the PPPoE client functionality to be moved to the Cisco DSL Router, which means you do not need to load PPPoE client software on each PC on your LAN. This feature also allows multiple PC clients to be connected to the Ethernet interface of the Cisco DSL Router and share the single PPPoE session between the Cisco DSL Router and the ISP gateway router.

This implementation includes configuration examples for Network Address Translation (NAT) overload, NAT Pool, Static NAT, and Dynamic Host Control Protocol (DHCP) Server.

Cisco IOS Software Release 12.1(3)XG or later is required on the Cisco DSL Router to support the PPPoE client feature.
PPPoE Option 2 The PC is the PPPoE client. This option requires PPPoE client software such as the Windows PPP over Ethernet (WINPoET) application to be installed on each PC on a local LAN.