Guest

Layer 3 VPNs (L3VPN)

mVPN Profiles

Techzone Article content

Document ID: 116321

Updated: Aug 02, 2013

Contributed by Luc De Ghein, Cisco TAC Engineer.

   Print

Introduction

This document provides an overview of the Multicast over VPN (mVPN ) profiles.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Overview of mVPN Profiles

This image provides an overview of all the profiles currently possible.

Note these details:

  • There are five columns that list the possible technologies that create the tree in the core network.

  • The green line divides the possibilities into two sets by encapsulation: Generic Routing Encapsulation (GRE) or Multiprotocol Label Switching (MPLS) encapsulation.

  • The yellow line devides the possibilities into two sets by their context: Multicast in the Global context or Multicast in the Virtual Routing and Forwarding (VRF) context.

  • There are three sets, each with an additional level of Border Gateway Protocol (BGP) signaling: No BGP signaling (except IPv4 Multicast Distribution Tree (MDT) for Rosen GRE), only BGP Auto-Discovery (AD), or BGP AD and BGP C-MCAST signaling (customer signaling of Multicast in overlay). An "additional" level of BGP signaling means a level in addition to the BGP signaling that is always needed for unicast over MPLS VPN.

  • There is a total of 18 profiles, numbered 0 to 17.

Updated: Aug 02, 2013
Document ID: 116321