How do I upgrade my Codian product using FTP?

Available Languages

Updated:April 23, 2015
Document ID:112262

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This article relates to the Cisco TelePresence MCU 4203, Cisco TelePresence MCU MSE 8420, Cisco TelePresence IP VCR 2210, Cisco TelePresence VCR MSE 8220, Cisco TelePresence ISDN GW 3241, Cisco TelePresence ISDN GW MSE 8321, Cisco TelePresence IP GW 3510, Cisco TelePresence MCU 4505, Cisco TelePresence Supervisor MSE 8050, Cisco TelePresence MCU MSE 8510 and Cisco TelePresence Advanced Media Gateway 3610 products.

Q. How do I upgrade my Codian product using FTP?

A. Simply send the upgrade file to your unit by FTP, using the user name "admin" and your "admin" account password, e.g. ftp a.b.c.d. where a.b.c.d. is the IP address of your Codian product. In the web interface, go to Settings > Shutdown. The new image will be listed as loaded and ready for upgrade. Proceed with the shutdown: Codian products check whether new software has been uploaded every time they are rebooted and if it has, perform the necessary checks and then install the new software.

Related Information

Revision History

Revision Publish Date Comments
1.0
23-Apr-2015
Initial Release

Was this Document Helpful?

FeedbackFeedback

Contact Cisco