Guest

Cisco Small Business IP Phones

SPA922 does not power on

Document ID: 109115

Updated: Dec 12, 2008

   Print

Introduction


This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).

Q. What should I do when the phone does not power on?

A.

Step 1:
Check all the connections into the phone: 5-volt power supply and RJ 45 Ethernet cable.

Step 2:
Check the wall socket and confirm that AC power is available.

Step 3:
Try plugging another electrical device into the socket to confirm power.


Note:? Remember the Linksys Voice System SPA922 is 802.3af compliant. Power over Ethernet allows devices that support PoE to receive their power from the switch, rather than from an external power supply. You need to connect it to a device that supports 802.3af. Below are some Linksys switches that are 802.3af compliant.

SRW2024P
SRW224P
SRW2008P
SRW2008MP

Related Information

Updated: Dec 12, 2008
Document ID: 109115