Tidal Enterprise Scheduler: Error Returned to Setting Ulimits for Job User

Available Languages

Download Options

PDF (5.7 KB)
View with Adobe Reader on a variety of devices

Updated:November 3, 2011

Document ID:113296

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

Prerequisites

Requirements

Components Used

Conventions

Problem

Resolution

Related Information

Introduction

This document explains the reason for the Launch error:- Error returned to setting ulimits for job user error message.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

The information in this document is based on the Unix Agent 3.0.1.09 or later.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Problem

In build 3.0.1.09 of the UNIX agent, an enhancement was added to the agent to support setting user ulimit values from /etc/security/limits.conf on Linux.

Resolution

On the agent machine, go to the install of the agent, and in the bin folder is a tagent.ini file. Add this parameter to the tagent.ini file:

ulimitold=y

Note: The parameter is case sensitive. The agent needs to be stopped and restarted after the parameter has been added to the tagent.ini file. If you set the parameter to y, this forces the agent to use the system settings. Put the parameter to n in order to force the agent to use the limits.conf folder located in /etc/security/ directory.