ACS Login Banner Configuration Example

Available Languages

Download Options

  • PDF     (974.1 KB)
    View with Adobe Reader on a variety of devices
Updated:July 11, 2013
Document ID:116283

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document describes the procedure required in order to configure Login banners on the Cisco Secure Access Control Server (ACS) Release 5.4 CLI and GUI.

Prerequisites

Requirements

Cisco recommends that you have knowledge of these topics:

  • Initial ACS Configuration
  • ACS CLI and GUI Access

Components Used

The information in this document is based on Cisco Secure ACS Release 5.4.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Configure

Note: The character limit for the "before" and "after" Login banners is 250 characters. You cannot configure separate banners for the CLI and GUI. Use the Command Lookup Tool (registered customers only) in order to obtain more information on the commands used in this section.

In order to configure the Login banners on the ACS CLI and GUI, complete these commands:

1. For the "before" Login banner message, log in to the ACS GUI. Navigate to My Workspace > Login Banner and enter the desired "before" Login banner message.

2. From the same location, configure the desired "after" Login banner message. 

Verify

GUI

The "before" Login banner message appears as shown here:

 The "after" Login banner message appears as shown here: 

 

CLI

The "before" Login banner message appears as shown here:

The "after" Login banner message appears as shown here: 

  

Troubleshoot

There is currently no specific troubleshooting information available for this configuration.

Revision History

Revision Publish Date Comments
1.0
11-Jul-2013
Initial Release
TAC Authored

Contributed by Cisco Engineers

  • Minakshi Kumar
    Cisco TAC Engineer.

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products