Guest

Cisco CTE 1400 Series Content Transformation Engines

Upgrading CTE Licenses

Document ID: 41025

Updated: Apr 20, 2005

   Print

Introduction

When the Cisco Content Transformation Engine (CTE) is upgraded from Release 2.5 to 2.7, you must install a license. This document describes that procedure.

Prerequisites

Requirements

Readers of this document should have knowledge of the CTE.

Components Used

The information in this document is based on CTE Release 2.5 and the upgrade to 2.7

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Problem

When the CTE is upgraded from Release 2.5 to 2.7, you must install a license. Release 2.5 did not have licensing enabled.

Problem Symptoms

If a valid license is not available for a particular device, then a device user who attempts to proxy web content through the CTE receives this message:

Please check with your administrator to verify that
the CTE has licenses for your device.

In addition, the CTE log file displays this messages:

httpd: session denied. check for sufficient capacity and device type licenses.
httpd: HTTP 403 (Please check with your administrator to verify that
       the CTE has licenses for your device.)

Solution

To obtain and upload an upgraded license, perform these steps:

  1. Send an e-mail to licensing@cisco.com with this information:

    Company Name
    Customer Contact
    Contact E-mail Address
    Original Service Order (SO) Number
    MAC Address
    Modules Purchased
  2. On the administrative PC where the CTE Administration Tool runs, create a C:\CTELicense directory (unless one already exists).

  3. Copy the license file (.lic) that you receive through e-mail to the C:\CTELicense directory.

    caution Caution: Do not overwrite any .lic files in the license directory. If other files exist in that directory with the same name, the newly received file must be renamed before you install it. The CTE software calculates licensed features based on all .lic files in the license directory.

    caution Caution: Do not edit a .lic file or the CTE software ignores features that are associated with that license file. The contents of the file are encrypted and must remain intact. If the license file is accidentally copied, renamed, or inserted multiple times, only the original file will be used. The duplicate files will be ignored.

  4. Open the CTE Administration Tool and upload the license, as described in the Uploads section of the Cisco CTE 1400 Series Configuration Note.

Related Information

Updated: Apr 20, 2005
Document ID: 41025