PDF(147.2 KB) View with Adobe Reader on a variety of devices
Updated:October 13, 2006
Document ID:1518931561588300
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
Product Bulletin No. EOL5003
Cisco Systems® announces the end-of-sale and end-of life dates for the Cisco 1-Port and 2-Port V.90 Modem WAN Interface Cards. The last day to order the affected product is February 5, 2007. Customers with active service contracts will continue to receive support from the Cisco Technical Assistance Center (TAC) until February 4, 2012.
Table 1 describes the end-of-life milestones, definitions, and dates for the affected product. Table 2 lists the product part numbers affected by this announcement.
Customers are encouraged to migrate to the 1-Port and 2-Port V.92 Modem WAN Interface Cards. Table 2 provides relevant information for migrating to the replacement product.
Table 1. End-of-Life Milestones and Dates for the Cisco 1-Port and 2-Port V.90 Modem WAN Interface Cards
Milestone
Definition
Date
End-of-Life Announcement Date
The date the document that announces the end of sale and end of life of a product is distributed to the general public.
August 7, 2006
End-of-Sale Date
The last date to order the product through Cisco point-of-sale mechanisms. The product is no longer for sale after this date.
February 5, 2007
Last Ship Date
The last-possible ship date that can be requested of Cisco and/or its contract manufacturers. Actual ship date is dependent on lead time.
May 6, 2007
End of Routine Failure Analysis Date
The last-possible date a routine failure analysis may be performed to determine the cause of product failure or defect.
February 5, 2008
End of New Service Attachment Date
For equipment and software that is not covered by a service-and-support contract, this is the last date to order a new service-and-support contract or add the equipment and/or software to an existing service-and-support contract.
February 5, 2008
End of Service Contract Renewal Date
The last date to extend or renew a service contract for the product.
May 3, 2011
Last Date of Support
The last date to receive service and support for the product. After this date, all support services for the product are unavailable, and the product becomes obsolete.
February 4, 2012
The replacement 1-Port and 2-Port V.92 Modem WAN Interface Cards (part numbers WIC-1AM-V2 and WIC-2AM-V2) are supported on the following platforms: Cisco 1800 Series, 2600XM, 2691, 2800 Series, 3700 Series, and 3800 Series routers. It is supported in the following minimum Cisco IOS Software releases:
• 12.3(16) Mainline or 12.4(4)T and later maintenance releases for the 2600XM, 2691and 3700
• 12.4(3) Mainline or 12.4(4)T and later mainline releases for 1800, 2800 and 3800
Table 1 describes the end-of-life milestones, definitions, and dates for the affected products. Table 2 lists the product part numbers affected by this announcement, and the mapping between the end-of-sale and replacement part numbers, and Table 3 lists the primary differences between the end-of-life and replacement WAN interface cards.
Table 2. Product Part Numbers Affected by This Announcement
End-of-Sale Product Part Number
Product Description
Replacement Product Part Number
Replacement Product Description
WIC-1AM(=)
One-port Analog Modem WAN Interface Card
WIC-1AM-V2(=)
One-port Analog Modem Interface Card
WIC-2AM(=)
Two-port Analog Modem WAN Interface Card
WIC-2AM-V2(=)
One-port Analog Modem Interface Card
PRODUCT MIGRATION OPTIONS
The recommended replacement for the Cisco 1-Port and 2-Port V.90 Modem WAN Interface Cards is the Cisco 1-Port and 2-Port V.92 Modem WAN interface Cards.
Cisco 1-Port and 2-Port V.90 Modem WAN Interface Cards
Cisco 1-Port and 2-Port V.92 Modem WAN interface Cards
V.90 (56Kbps connect speeds)
Yes
Yes
V.92 Quick-Connect (faster connection times)
No
Yes
V.44 Compression
No
Yes
Line rate aggregate throughput
No
Yes
Dynamic modem stats updates (during a modem call)
No
Yes
Customers can use the Cisco Technology Migration Plan (TMP) to trade in products and receive credit toward the purchase of new Cisco equipment. For more information about Cisco TMP, go to
http://www.cisco.com/go/tradein/. The Cisco TMP application requires all users to have a Cisco.com user ID.
Customers may be able to continue to purchase the end-of-sale product through Cisco's Authorized Refurbished Equipment program. Refurbished units of the end-of-sale product are available in limited supply for sale in certain countries on a first-come, first-served basis. For information about the refurbished equipment program, go to:
http://www.cisco.com/en/US/ordering/or6/or17/order_refurbished_equipment_program_description.html
Feedback