Sending Advanced Commands for the Cisco Unified MeetingPlace 3500 Series Media Server

In the Advanced section of the Settings tab, you can send text-based commands used for the enhanced control of the Media Server. Advanced commands are not case-sensitive.

Note     We recommend that only advanced users or users who have consulted with Cisco Customer Support perform actions involving advanced commands.

Table 2-6 lists all of the available advanced commands.

Table 2-6 List of Available Advanced Commands 

Command

Description

Parameters

Default

CS Log

Show—Dumps detailed information on the internal status of the Media Server.

Start—Initiates a "Show" operation and enables detailed logging for the Media Server.

Stop—Initiates a "Show" operation and changes the log levels to the ones used before the "Start" operation.

Show, Start, Stop

 

Font align

Determines whether text overlay (TOL) on a video screen is positioned away from picture borders.

All—Text positioned away from horizontal and vertical borders.

Horizontal—Text positioned away from horizontal borders and centered horizontally.

Vertical—Text positioned away from vertical borders and centered vertically.

None—Text is always positioned bottom center.

All

NTP synchronization period

Sets the Network Time Protocol synchronization period (in seconds) between the Video Blade and the NTP server.

 

21600

Notify level

Sets the Media Server log notify level filter.

Fatal—The Media Server cannot continue to provide service. This is an unrecoverable error.

Error—User functionality problem (for example, call connect failure or no resources available).

Warning—User functionality problem but the Media Server can continue to provide service.

Info—Status prints for Customer Support use.

Advanced—Similar to Info but more detailed.

Debug 1 through Debug 4—Debug levels.

Debug 3

QualiVision Settings hide

Disables the QualiVision Settings section in the Settings tab.

 

The QualiVision Settings section is hidden by default.

QualiVision settings show

Enables the QualiVision Settings section in the Settings tab.

 

The QualiVision Settings section is hidden by default.

RTP base port

     

SIP bandwidth attribute type

     

SIP hide stack

     

SIP show stack

     

SIP show status

     

SIP video capability description type

     

Set MTU size

Determines the maximum packet size across the network.

 

1500

Set terminal baudrate

Sets the baud rate of a serial terminal.

High (57600)

Low (9600)

Low (9600)

Procedure

  1. In the MSA interface, on the sidebar, click MCU.
  2. Click the Settings tab.
  3. Click Advanced.
  4. Click Commands to open the Advanced Commands window.
  5. Enter a command in the Command field, or choose a command from the Available Commands list.
  6. Enter a parameter value for the command (where applicable) in the Parameters field, or choose a parameter from the Available Parameters list.
  7. Click Send.
  8. The system displays the results of the advanced command in the Response field, indicating whether or not the Media Server received and executed the command. If you send an invalid command, the system displays a "bad parameter" or "NOT FOUND" message.



Copyright © 2002-2008, Cisco Systems, Inc. All rights reserved.